Posted by tcanthonyii on December 28, 2008 at 21:03:27 from (71.31.200.148):
I'm going to an auction in a few weeks and they have 2 farmall 560's. One auction bill states that both 560's are for parts and the other states one as for parts only. At any rate I haven't seen them yet so I don't know of the condition. Will a 560 fast hitch fit onto an M? If I could get these cheap ( the statement on the auction bill is
"Condition of Machinery and Improvements – The Machinery Has Not Been Used For Several Years, Obsolescence Is Obvious, Much Is Salvage, Some Badly Vandalized. The Outbuildings Are Old, Unattended Valued Only For Their Materials. The 1,600 Square Foot Home Needs Restoration, See Below."
If it does or if i can be it may be cheaper than getting a full 3 point setup. All I really want the hitch for is to pull a rear blade, a mower at some point and just to have a drawbar to move trailers around (which would be it's main use).
Will any other parts off a 560 fit an M? My Father in law is thinking of buying them anyway just to fix up be we'll see.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.