Farmall & IHC Tractors Discussion Board |
Re: Re: Re: M Leaking Tran Oil
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on June 08, 2000 at 11:07:58 from (206.246.187.2):
In Reply to: Re: Re: M Leaking Tran Oil posted by Frog Level on June 08, 2000 at 10:53:34:
No you do not need to split the tractor. The transmission driving shaft coupler is bolted on. Remove the bolt and washer, and try to use a pry bar to slide it off. It is a good one inch thick. Once it is off you then unbolt the transmission driving shaft bearing retainer which contains the oil seal. Put it upside down in the workbench and the seal punches out real easy. The retainer gasket behind the retainer may be fine but I usually replace them at the same time. If you have trouble getting the coupler off, you might have to remove the liftall to give yourself more room to make up a puller. I fabricated one for Old Red H. It took 3 hours to get that durn thing off. The transmission counter shaft coupler is screwed on like the liftall one. Put the machine in gear and it comes off counterclockwise. then you unbolt the retainer base and you can swap out that seal and gasket like on the main coupler.
Follow Ups:
Home
| Forums
Today's Featured Article -
A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|