Output speed of the engine wont be fast enough to run the hamer mill so you will need pulleys and belts. The belt pulleys ran like 1200 rpms and the hammer mills pulley was always smaller then the tractor. So you will need to do some serious figuring when getting your speeds correct. Isnt any reason why it wont work if you get your speed down pat. Capicity wont be that great as the motor doesent have that mush HP unless its the engine for the A and B tractors. I have ground tons of feed with the B on the belt using old Montgomery Wards traveling table hammer mill Probably was a 7 in remembering the screens.Blew the ground feed around 15ft upstairs to the load-out bin and also the other bin that fed the self feeders. Had three chutes out of that bin so gravity would fill them. Load out bin was loaded onto flared box then hauled to the feild and scooped of into the feeders. Raised lots of hogs more in the summer out on pasture.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
