I borrowed a depth mic and rechecked the sleeve stick-out. Found that the max is .003 - most measurements were in the .001-2 range. Using the end of my old calipers wasn't doing a very good job of measuring. So I should be OK there.
Someone here locally asked if I had retorqued the head. I had not done that - manual didn't say to. Should I have to retorque them? If so, how long should I run it before a retorque?
On the detonation possibility... I pulled apart the distributor and found that the pivots on the advance weights had a lot of slop and the springs looked a bit stretched. Would this be enough to give me detonation issues?
I checked with the IH dealer and they can't get new springs anymore. Steel Wheel Ranch has some used springs, but I have no idea if they would be any better than what I have. Anyone know of a source for NOS springs or a way to verify if mine are OK?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.