Unless you were doing a TOTALL teardown(which you obviously DO NOT need.) I would not go near the engine or the trans/final drive with a pressurized sand blaster at all! Most people do not realize that the sand under that kind of pressure WILL get into areas you dont want it to! I dont care HOW much duct tape,corks,plugs,block off plates you use.
You might look into low pressure,[lastic media blasting,but it will still enter any cracks or crevases. A good cleaning and some hand prep work like posted below will produce "show quality" results.It is in the detail as to how much you want to "work" at the prep job???? The prep work IS the key to GREAT paint.period!!!!
Even if you DO choose to sandblast it,you will have as much prep afterwards as you would have if you didnt blast it. (Sand clean up,taking it FARTHER apart to get the sand out of areas it should have NEVER been.) IMHO,If I were going to blast it,I would start tearing it apart even more than it is now.You wount get good coverage with the sand.TOO many angles to hit.You will find yourself taking things apart afterwards to finish them.
The old paint that is on it+ MORE primer will work good as a base IF IT IS PREPPED CORRECTLY! ;) I am sure I will get arguments here. :) Unless a tractor was a "rust bucket" of a chasssis,(which yours OBVIOUSLY is not!) I wouldnt.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.