Farmall & IHC Tractors Discussion Board |
pressure relief not working
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by IaGuy on December 02, 2000 at 07:57:48 from (24.149.14.30):
I put a double acting cylinder loader on the 450 hydraulic system. The loader went only part way up and then pump cavitated. Put in oil while loader up on a barrel, then oil ran out of tank when looder came down. Pressure relief worked when valves in neutral and engine idled ok. Read the book, adjusted to thingys on top of valvebodys, now loader goes up high, but when valves in neutral , engine struggles against load.So I drive around twiddling the levers but what could I have screwed up?
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Diesel Vs. Gasoline - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I am in the market for an older tractor (to be read... cheap). I have been told a diesel holds up better than a gasoline engine as far a wear, tear, neglect and abuse. Since I am looking at older tractors that have probably been through it all, is it better to buy diesel? I do expect to have to do a good bit of work on
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|