Posted by wm. Ecccles - Jardine on January 15, 2014 at 07:43:17 from (199.91.214.32):
I know this is extremly early in the year to ask this question with SNOW still some FEET deep in parts of North America; USA and CANADA;; I have an old A - C 21 Mower which I have had in parts and stored for a number of years. This spring I would like to start reassembling it and set it up for cutting weeds and clean up such like.My owners manual gives very scant informatiion on adjustment of the sectiions to guards. ???? Do any of you have a more accutae set of information other than the following which I quote" There should be perfect sheating between the sections and the ledger plates, that is, the tip of every sectin should lie smoothly on the ledger plate." This to me is nebulus information. Should the two parts be close enough to easily shear a thin piece of paper or should it just bend the paper. The wording would have made sence to my father since he had worked with mowers all his life on the farm; but not to me who has been away from if for nearly 50 years 1965 till now. Thank you for all your clear accurate presice information. Wm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
