Farmall & IHC Tractors Discussion Board |
FARMALL SUPER M 12V CONVERSION - BOB MELVILLE
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tennessee Transplant on January 28, 2001 at 12:51:26 from (205.188.196.53):
By using the Bob Melville's 12-Volt Conversion Instructions (posted under Articles) I successfully completed the project using a Delco 10SI (1978 Buick) Alternator. I fabricated the bracket by flip-flopping the OEM Generator Bracket which set it forward about 1"; opened the bolt holes to 3/8". To set the Alternator in-line with the drive pulley you have to place the alternator in front of the OEM bracket. I used a 9" X 3/8" bolt; threaded all the way down to last 2" from end. By using the pulley that came with the alternator, the OEM generator belt nearly fit, however, it was a tad short. A NAPA 9345; 31/64" X 34-7/8" did the trick. I fabricated an ajusting arm using a 3/4" strap iron with a 2" forward offset and a slotted adjusting arm end from a junk car. The final belt tightening was only 1/4" or so...as everything fits up just right and you have very little room to play with...nothing touches the hood....all fits with adequate clearance. See photos... Thanks, Bob, for your detailed instructions!
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|