Posted by JD Seller on May 15, 2011 at 21:00:27 from (208.126.196.144):
In Reply to: pole barn posted by Matt McKinney on May 15, 2011 at 17:43:17:
They usually will not bargain on a building. I have two Morton buildings. One was built in the late 1960s. The other in the 1980s. They both look like new yet. I had a Lester building built in the late 1970s. The metal did not last for ten years on it. Many here will bad mouth a Morton building mainly because they would/could not build one. They are one of the best quality building out there. You do get what you pay for.
If you want to get most of the same quality but make it more afordable then ask them about their "Country Craft" line. They have most of the same features but with thinner metal and shorter warranties on paint peal. If I could not afford the main Morton building then I would look long and hard at the Country Craft line. Also I have never heard of a Morton coming down under snow load. Many of the others have had them crash.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
