I have both, Semi-Mount 4-16" and 3-14" fully-mounted.. The F-145, be it 14" or 16" will go in the ground, if the shares are good and it is adjusted properly.. With the plow raised, how close is the "Frog" to the edge of the share..? Those shares can get badly worn down and you not realize it....then they won't go in well at all.. Same for Blacksmith-type shares.. If it is not going "IN" well, how are you ever going to obtain any weight transfer for traction..!! On the rear, a miss-adjusted Heal, or tail wheel can prevent that end from going in deep enough (or Worn Shares).. On the Front, the depth is pretty much determined by the depth of the lower arms of the 3-Point and the condition of the Shares.(assuming the plow is fairly well Scoured)..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
