1. I don't think the trade in value of a non-running Silverado will offset the cost to get into a Cummins, so that's not an option. 2. Had the fuel filter changed about 2k ago. 3. Pulled the bleeder screw loose and turned the motor over and no fuel came out. 4. Cracked the #5 injector line and cranked motor over and no fuel 5. Blew air pressure into the tank (used an air hose and a rag to seal up the tank) and got fuel to puke out the bleeder on the filter. 6. Checked with an OBD2 Scanner and found no codes 7. Pretty sure it has fuel in it. Only 200 Miles on this tank and mileage is consistent with fuel gauge reading (little under 1/2 tank). 8. Unplugged the batteries for 10 minutes with wild ambition that if there was a electrical problem it would magically fix itself 9. Checked all the fuses. 10. Swapped the relays around and all seem to work.
My gut tells me it's the pump, but my wallet hopes it's something simple. I couldn't find a frame mounted transfer pump, I'm assuiming the injection pump is also the transfer pump.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
