Posted by Bob on June 14, 2011 at 13:14:03 from (64.255.159.192):
In Reply to: Re: Magneto Problem? posted by Adutkiewicz on June 14, 2011 at 13:04:53:
First, take off the little cover just under the rotor (2 screws) and see if the gears are correctly timed. Instructions are in the Blue Ribbon Service Manual at the link below.
Make sure the engine is rotated to the #1 TDC position at the end of the compression stroke.
Then, (before installing the mag) rotate the mag BACKWARDS so the impulse doesn't catch so the rotor points to the #1 high-tension tower. Set it so the points have just closed going backwards/begin to open when it's turned forwards.
Install the mag and the wires (in firing order).
Be SURE the kill switch is set to "OFF".
Rotate the engine exactly TWO turns, approaching #1 TDC SSLLLOOOOWWWWWLY, and verify that the impulse snaps AT (NOT before) TDC.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
