JDSeller, I'm glad you took my post in the spirit it was meant.
As I said, my experience is on the automotive side, so I realize that the farm equipment/short line side IS different. Pap and Grand-dad sold FMC SideWinder mowers in the late '60's/early '70's, until they pi**ed Pap off by granting a second dealership in the same county. The ONLY warranty problems we ever had was with a BD-90 mower behind a Super M. Apparently, SideWinder thought that folks would buy a 90-inch-wide finish mower in about 1974; the farmers 'round here thought that it should be able to cut stuff as high as the platform on the Super M, and that tall stuff would just make the belts smoke. SideWinder sent a factory engineer out on that one, and he came up with a "repair," but it wasn't a total fix. SideWinder bought that mower back from the man with the Super M, and we sold him a 6x6 instead...and he was a lot happier in the end.
Well, there WAS that one time that ol' Joe Kintner brought in the PTO shaft from his 6x6 mower looking like a pretzel twist. SideWinder bought the FIRST one...On the second one, we discovered that ol' Joe was using grade 8 bolts as shear bolts, and they weren't shearing worth a damn. Joe bought that PTO shaft himself, and we sent him out the door with a small bag of the CORRECT shear bolts, and everyone went home happy that night. That ol' W-9 could really put some torque out, apparently.
And at the Farmall garage, Pap and Grand-dad went by the I&T flat-rate manual, not the IH factory flat-rate manual. Don't know that I ever saw an IH flat-rate manual when I was growing up around the shop. Pap and Grand-dad tried to discourage me from going into the biz, but I had too many years behind the parts counter [10 years experience by the time I was 18], and I just couldn't stay away. BUT the automotive side paid a lot better, back in the '70's and '80's at least.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.