Not sure of the manufacturer, bought at Menards, can look tonight.
Total length 8', buried just under 4' of it. Dug a big well at the bottom and put in probably a 2'x4'x1.5'(deep) bed of crushed rock, under and around it is all clay. Only time I had trouble was the first winter I had it installed, I had a pipe freeze near the house (not the hydrant's fault) so I went down to water the horses and when I got no water I left the darned hydrant on so it froze in the on position. Got it thawed with water from a kettle and fixed my other problem and it has been great.
If I were doing it again I would bury it a bit deeper, maybe so it's only 3' out of the ground, not for freezing but so it's easier remove full buckets from for the wife. Any way you do it, it sure beats hauling water from the house in buckets which is what I did the first winter we were there.
Oh, one more thing, I would have had the rain hold off for about a day or two more after I dug the trench. Connecting pipe and installing a hydrant is much easier if you are not in a 6-7' deep mud pit!
This post was edited by Inno at 14:31:12 07/15/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
