Posted by Rick from NC on July 21, 2011 at 16:24:32 from (75.143.187.32):
In Reply to: 1969 Ford 4000 posted by TMo on July 21, 2011 at 14:25:00:
Lot's of folks have dumped the Holley for a new Zenith. They run about $300 and are available from this site. I'm still running the Holley on my 4400 but the only issue with mine is a stumble if you give it to much throttle before it warms up.
I made up a wiring harness for mine when I rewired it. It was pretty simple but if I had it to do over I would have just bought the harness. Most parts places list the diesel harness but I've heard some actually include the wires for the gas models also.
I converted mine to an alternator and electronic ignition also.
Lot's of experienced folks down the page on the Ford board
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
