Posted by IaGary on September 15, 2011 at 19:42:39 from (69.63.5.162):
In Reply to: Re: cattle waters posted by IOWA NORTHEAST on September 15, 2011 at 18:14:00:
Over the past 40 years dad and I have installed over 100 of the Richies.
I don't recall any problems with those angle iron hold clips. We never had one break loose anyway. We always poored a 2 inch higher slab just big enough for the water and hold downs to keep both up out of the pooh.
As far as longivity it depends on your water. Some water would eat the old steel ones in 5 to ten years. We got 30 years out of a lot of them.
It was a farm to farm thing on the life of them before the stainless steel ones depending on their water.
Which brands do you like better? Lots of the other brands are using Richie ideas.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
