"lets keep it simple, don't need fifty guesses, just the facts [dragnet,lol] i like autolites....
Since youre NOT concerned with AM radio noise on your tractor and since (especially if a Magneto) you dont need to waste any energy in heat dissipation in a resistor plug, you would want a NON RESISTOR PLUG and below is what the Autolite application chart has to say
AUTOLITE 3116 Product Type Non Resistor
Description Loose Terminal Nut
Heat Range Chart Location C20
Hex 7/8"
Reach 1/2" Non Resistor
Seat Gasket
Thread Diameter 18MM
HOWEVER any plug can gas and/or carbon or oil foul if shes an oil burner or the compression is low or youre running too rich remember
Sooooooooo my advice/opinion NOT fact is to keep the temperature up to at least 180 (T stats or radiator air restriction) ,,,,,,,,,,,Dont run the carb any richer then necessary,,,,,,,,,,,avoid long idle periods,,,,,,,,use a NON RESISTOR PLUG,,,,,,,,
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.