You need to remove the axle nut(should be 36mm) and the three bolts that come into the back of the wheel bearing/hub assy(should be 12pt. 13mm).
The bearing/hub assy can be difficult to remove. If your axle shaft has u-joints... 1. turn axle shaft so u-joint is oriented like a +(as opposed to an x). 2. place a large socket between the axle tube and the u-joint yoke on the hub side of the axle shaft. 3. turn steering wheel to apply pressure from socket to rear of hub via u-joint yoke. 4. move socket to opposite side(ie: if you were on the back side, move to front) of axle tube. 5. turn steering wheel in opposite direction to apply pressure to hub again. This will gradually and evenly push the wheel bearing/hub out of the spindle.
If you're dealing with a CV type shaft instead, use a large punch to rotate the wheel bearing/hub in CW/CCW direction slightly to help loosen it from the spindle. Also apply light/penetrating oil applied between hub and spindle.
You will want to pop the ball joints as the last step in the process.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.