Posted by rpirkle1 on October 04, 2011 at 09:40:08 from (71.59.9.111):
In Reply to: Barn Door Latch posted by NW Ohio Tim on October 04, 2011 at 09:25:49:
Hi Tim,
I don't have a picture.. but what I'm thinking is something like a drop bar and rope.
Left door gets a catch (be it a piece of pipe or steel or 2x4) that points into the barn.
Right door gets a bar with a groove/notch cut to drop over the catch on the left door and single bolt to hinge it.
Rope with hole 2-4 feet higher on right door so while you're outside you can pull to left the bar.
Bar needs to be long enough to where it's easy to hinge
Or if you are looking to latch secure enough to stop thefts, you could rig it the other way (bar/catch on the outside with rope ran to the inside) with a lock on the outside.
Have seen it done with 2x4 on farms and around RR stuff with 1/4 steel, just don't have a picture.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
