Posted by Brian Jasper co. Ia on October 16, 2011 at 18:44:20 from (67.142.130.11):
In Reply to: 05-07 Ford 6.0 problem posted by Jeff Oliver on October 16, 2011 at 05:30:04:
How does he know the oil pressure went to 90? The factory gauge is really a "dummy" gauge. They read about the o or r in normal once oil pressure passes about 7 psi. Turbo rattle? They are known for the unison ring sticking. I suppose it"s possible for the turbine to be contacting the housing. If that be the case, it"s just a matter of time before the turbo has a major failure, usually broken shaft. Depending on where the unison ring sticks dictates on weather they run good or poor. Boost should never go above 25 psi or there will be a set of headgaskets in your future. An indicator of leaking headgaskets is pushing coolant out the overflow tank cap. It"s not possible for the EGR valve to pressurize the crankcase. Typical EGR issues are sticking open causing lots of black smoke. With a speed/load concern I would first do a low side flow test on the fuel system. Fuel pressue shouldn"t ever dip below 45psi. Below 45 you start hammering injectors. Hammered injectors usually show up as misfires on a cold start up. If you take it to the dealer, they"re highly likely to want to put fuel filters in. I recommend getting Ford filters. Aftermarket filters don"t have a water separator (Wix included) like the O.E. do. You can change them yourself and save a few $$. Don"t forget to drain the water trap, it"s the 6mm allen plug on the side of the lower filter housing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.