Posted by RayP(MI) on November 01, 2011 at 18:06:47 from (207.241.137.116):
In Reply to: 3 point dirt scoops posted by petemiddletn on November 01, 2011 at 13:25:28:
Using one today - and a couple days before. Hauling gravel to fill in a few hundred feet of farm lane where trucks cut in. Can back into gravel pile, and load easily. But have to hop off tractor to dump, as can"t release by pulling the rope. Works OK with Massey 180, however geometry on Farmall 200 with 2pt/3pt conversion just isn"t right. Main problem I"m having right now is small capacity. Spending a lot of seat time to move a small amount of gravel. Just the cat"s meow for hand rock picking - can lower to ground level, roll larger rocks in, back up to edge of field and dump without handling rocks twice. Not a real good substitute for a good loader tractor with large bucket, but works for me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
