Posted by dr sportster on November 05, 2011 at 10:44:27 from (69.125.160.50):
In Reply to: OT - NM-B Wire posted by 61-4010 on November 05, 2011 at 08:47:46:
I'm not looking in the code book.Usually I just make up some hairbrained answer so here goes. Normally RX does not go into pipe. Almost every buried pipe will get water inside . That cable you spec has paper inside that gets wet and and the copper will slowly [very, very slowly] detiorate. The proper cable would be UF . If you use UF you don't need the pipe. However it is fine to sleeve it if you desire. I have seen inspectors not wanting UF to be brought through the house and wanted a transition made to RX once entering the home . This is an utterly ridiculus requirement.But ...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
