Posted by LJD on November 12, 2011 at 18:19:41 from (67.142.130.44):
In Reply to: Diesel Fuel Additive posted by wolfman on November 12, 2011 at 17:25:04:
It's not a matter of "working" or "not working." It's a matter of shortening the overall life of mechanical rotary injection pumps that aren't used on newer vehicles. Many farm tractors though, as well as Chevy/GM SUVs and trucks, Ford trucks up to mid 1994, Dodge trucks with Bosch rotaries, etc.
If you have an in-line injection pump, it's not an issue. An in-line pump actually has a separate injection pump for each cylinder and no distributor to worry about. It is the distributor that causes the big problems with low-lube fuel.
The new fuel does not have the same lube as the old fuel did. When the sulfur is cooked out of it, lube is lost. As a result, lube additives are put back in before it gets to the pump, but that will vary and still does not bring the new fuel up to the same lube level of the past.
A well cared for mechanical rotary pump can last 1,000,000 miles. It may get sent back to the shop for so-called rebuilds 3-6 (more or less) times, but often all the major moving parts are use over again, as is.
So, I suspect most people will never know when their pump life was shortened - unless they know it's actually new inside and then goes bad in short order.
For a non-emissions car, truck, or diesel tractor using two-stroke-oil at a 1 to 400 ratio gets the lube up to where it ought to be and it's usually the cheapest/effective additive. I buy it in gallon jugs at Walmart. I only use it on my highway diesels. For my tractors, I use medium sulfur dyed off-road fuel that does not have the low-lube issues - yet. But I'm in NY. In some parts of the USA, dyed fuel is ultra-low and DOES have the issues.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.