Posted by Paul from MI on November 13, 2011 at 07:05:22 from (70.165.188.151):
In Reply to: OT electric posted by Budd on November 13, 2011 at 04:29:06:
As John T says, yes it can be done and be safe and legal. BUT, you can't use the existing groundING conductor for anything except that and you must provide a grounding conductor for the 120V outlet. You will need to replace the 240v-2 pole-probably40amp breaker or fuse with a 120v-single pole-20amp fuse or breaker. either the red or black wire can be connected to this which now becomes the "hot" for the receptacle. The other insulated conductor must be identified with white tape or paint whereever it is exposed, in both the panel and the receptacle box, and connected to the neutral bus in the panel. It now becomes the neutral for your receptacle. In a nutshell, you must provide an insulated hot protected at no more than 20 amps, an insulated identified white neutral, and a GROUNDING conductor to feed your new receptacle. Given the space needed to make splices to 12 ga. wire to fit a receptacle this may not be so easy. It probably will be easier to leave the old circuit intact and pull as complete new one. DO NOT USE THE EXISTING GROUNDING CONDCTOR AS A NEUTRAL AND DO NOT CUT OFF SOME OF THE WIRE IN THE EXISTING CABLE TO MAKE IT FIT THE RECEPTACLE ASND DO NOT USE THE EXISTING 30 OR 40 AMP PROTECTION. Good luck with the project.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.