You didnt say what current draw the 12 volt pump creates????? but some typical supply devices (12 VDC outlets, sockets, etc) are rated for maybe 300 watts which would be 25 amps.
To answer the question we need to know the maximum curent draw and the max rating of the socket/outlet and go from there, but not knowing I'll take a guess and Id supply it with 10 gauge wire and use a 30 amp fuze or circuit breaker at the source. NOTE That could (depends on its rating) exceed the outlet socket/device rating and if so (say its rated 300 watts) then you would have to downsize the fuze or breaker to 25 amps. I would NOT use less then 12 gauge wire regardless and if you use 12 gauge wire then you would use a 20 amp fuze or circuit breaker.
If theres an ammeter Id use its LOAD (NOT battery) terminal as the voltage source, but if no ammeter you could use the hot ungrounded battery post as you asked with the fuze or circuit breaker there.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
