Posted by donjr on December 30, 2011 at 22:02:57 from (71.248.71.15):
In Reply to: New pick up opinions posted by Truck died on December 30, 2011 at 21:03:07:
I love my Chevy. But, if you are going to actually pull anything, I'd tell you to get a 3/4. You can get away with a smaller mill, and you don't need a 4.10 rear. A 350 (6.2L?) won't kill your mileage, and give you plenty of drag. But the biggest problem you'll have is whoaing the thing. The brakes and springs are much heavier on the 3/4 vs. the 1/2. None of them are cheap, but you'll get much better service out of it if it isn't overwhelmed to begin with. And you can upgrade a 3/4 to a ton by taking it to the spring shop and adding a few leaves if it's too soft.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
