Posted by RodInNS on January 12, 2012 at 20:58:51 from (216.118.158.123):
In Reply to: Lx565 water pump posted by Jacksonduper on January 12, 2012 at 20:25:06:
Where to start................ First of all... How do you know it's hot? THe display? Is it pushing coolant out? Have you checked the head temperature with an IR heat gun? Just because the diplay squeals at you or gives you a shutdown doesn't mean it's really hot... If you're getting erratic temperature changes on the display I would suspect the wiring first before the actual temperature. Beyond that I would check the belt tension. Pull the rad clear of the cooler and really get in there with high flow air and BLOW the crap out. Then I would probably drain the cooling system and run a bottle of commercial cooling system flush through as directed and pull the lower rad hose and backflush again and again until it runs clear with no suds...
The short answer to your question is that if the water pump is bad... it will probably be loose at the bearing and the fan blade will have noticable movement... and when they get really bad the seal will leak and you will see drainage from the weep hole in the front of the pump housing as a result. One that is just starting to go will often not leave a puddle of coolant as it will evaporate on the engine front cover and just leave a green tracer running down the cover from the drain hole. So... verify the temperature with a heat gun... then proceed through checking the belt (as they do eat belts up), blowing the rad clean, flushing the cooling system... and then you can start looking at bad thermostat or a pressurised system from a bad head gasket.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
