Posted by buickanddeere on February 03, 2012 at 05:33:06 from (209.240.114.221):
In Reply to: Re: answer this then posted by biggerred on February 03, 2012 at 04:30:22:
Measure the resistance, voltage gradients and current running through grounding systems. Then get back to us. Testing between the ground and neutral at the panel closest to the utility service with an ohm meter? You think that shows anything other than you have no clue about raised ground potential and neutral current on ground systems? Another thing, just how often are incorrect or damaged ground and neutrals found? So again how is it you know more than the writers of the NEC ? You are the type of electrician that couldn't figure out why patrons of a local pool were getting shocks. The municipality had already removed the metal fence outside and replaced it with wood as they couldn't figure out why people were receiving shocks there too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
