Posted by RayP(MI) on February 11, 2012 at 13:52:54 from (207.241.137.116):
In Reply to: Earthway Planter posted by Ed The Wine Farmer on February 11, 2012 at 12:37:33:
I mark my garden with a drag (springtooth harrow) behind a farm tractor. (You"d be suprised how straight I can drive if I try.) Then just pick the appropriate groove for my rows. Seed a lot of sweetcorn with that planter. Used to use a funnel with a hose, hand dropping the seed. Earthway works far better, faster. Easier on my back! Does tend to skip a few hills now and then, as the corse, rough seed sometimes hangs up. (I usually replant in a couple weeks, to extend production season, so not a big problem.) Beans and other seeds feed very smoothly. Spacing could be increased with a little duct tape over a few holes in the seed plate. Oh, I usually have to cover the planted rows with a gently applied hoe. But far easier than hand planting - not perfect, but pretty good, is my evaluation.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
