Posted by JMS/.MN on February 14, 2012 at 21:39:26 from (209.237.107.155):
In Reply to: Re: Case IH 4694 posted by IHMANKY on February 14, 2012 at 19:07:33:
You do not want to hit the crab steer (or make even a slight correction) when in road gear! You"ll take a 45 right into the ditch. Otherwise, nothing to worry about. I used a 6-18 semi-mount plow on it.....something you cannot do with an articulated 4WD. They will break the plow with the side to side action. Leave it in front wheel steer and the plow follows like on a conventional tractor. Does increase the turning radius, but after 12 furrows you don"t need to turn short- just that first round. 4690 and later is when you get into the electronics stuff. 2470 is all mechanical.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
