I do manual labor based on my ability to do it in a timely fashion (esp in the Houston heat).
I use a reel mower for my lawn, a special hand edger for the sidewalks, but I use a Stihl weed whacker for edging against the buildings and fence.
I just removed a stump, and used an axe to cut all the way around the roots. I used a come-a-long to pull it out. To dismantle the stump I pulled out the chainsaw. When I took the tree down I used a manual pole saw for the tall stuff, then the chain saw for the remaining large limbs.
The past two years I used a shovel to turn my garden. With the clay and the leaves I was trying to mix in it didn't work too well. I now have a walk behind tiller for this year.
My drill press is a hand cranked post drill I refurbished in January. I mostly used a hand wire brush to clean off the rust (a couple of spots I used a drill with a brush but only in some tight corners).
One of my favorite PBS shows is the "Woodwright Shop". I have made several of his projects with as much hand tools as possible. I build a dovetailed bookshelf for my apartment on the floor with hand tools and my legs as a vise.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
