first thing is to make sure it will turn over by hand.trying to break one loose by pulling is sometimes not the best way.Next make sure you have brakes on the pulled tractor.then put it in high gear,and give it a pull.(after making sure you have gas and fire of course)a w series tractor will bust right off if its firing correctly.and they are not hard to crank.one reminder though,if you do decide to crank it,never ever wrap your thumb around the crank. simply roll engine over to compression turn crank until you can pull up, lay handle in palm of hand and give it a sharp pull up.all it has to do is rollover tdc once and fire and it will run.your wc probably will still have a mag unless someone has changed it over the years.well worth your time to go ahead before you start and clean the points. good old tractors,dont know if i could get used to those hand brakes again though! one word of warning DO NOT trust the spring on your crank to disengage handle from front pulley.they have been known to hang and it can very easily knock you down and beat you to death!before you do use your crank inpect it for grooves where the pins on shaft engage.if it has grooves either file them away,or Replace parts with new.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
