Posted by flying belgian on February 20, 2012 at 09:08:17 from (98.132.233.132):
I have decided to get a deep ripper to break up the hard pan just below my moldboard plow. Now I have heard that an inline ripper set at 30" between shanks will shatter the ground more then a V-ripper set at 30". Reason is there is more distance to the next 30" shank if you measure diag. on a v-ripper. Anyone have experiance with ether one? What if you would take a v-ripper and set the diag. distance to 30" making the witdth on the ground maybe 26"? I thought I had my sites set on a Kinze 2500 with coulters and cover disks for $6900. They are a straight bar. But now I found a JD v-ripper with out coulters and cover disks for $2200. Quite a difference in price. I don't need coulters as I am going to be ripping bean ground only. I do need the disk levlers but I can make some for the back of the JD and still save a lot of money. Those of you that have used them, any thoughts? Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.