Posted by jackinok on February 29, 2012 at 08:13:13 from (162.58.82.136):
In Reply to: Subsoiler posted by SouthernFarmall on February 28, 2012 at 17:45:53:
very few if any farm tractors have pressure down.try shortening your toplink! that subsoiler pulls itself into the ground just like a plow.once its setting level on the bottom you cant make it go deeper regardless,even with pressure down you probably would just lift back of tractor.sortening your toplink angles blade down more .once its as deep as you want it,or as deep as you can pull.youve got it set.those folks pulling one that deep ,are either subsoiling sand ,which does nothing,or using tons of hp to do it!remember a subsoiler doesnt just cut a groove in the earth,it actually lifts the dirt around it breaking it up from the bottom,sort of like a plow in reverse.it takes a lot of power.and just between you and me not all soils benifit from subsoiling. its better done in the driest part of year,because if you do it when ground is wet it simply closes back up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
