Posted by jimva on March 11, 2012 at 11:16:54 from (71.171.21.80):
In Reply to: Nanny State-- posted by donjr on March 11, 2012 at 09:58:41:
Yep i can believe it. Thanks to the good ole EPA and Chesapeake Bay Act.
My brother is a building and excavating contractor and you wouldnt believe the hoops you have to go through to be in compliance with the erosion and sediment control on a jobsite. Whether its a commericial job or a simple house. Have to have silt fence around the entire property, all dirt piles have to be seeded if there not used within 10 days, when you seed a new yard and put straw down you have to spread a thin layer of mulch over the straw to keep it (the straw)stabilized, after every rain event they send out inspectors to the jobsites to inspect for run off etc etc etc.
However for now in Virginia Agriculture and Forestry activity is exempt from it. If things get to hot for the landowners you may want to tell them to check the local ordinances to see if Agriculture is exempt in Maryland.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
