Posted by omahagreg on March 16, 2012 at 18:15:39 from (72.213.46.156):
As a trim carpenter, I depend on my air nail guns. Have 3 different types for doing trim specifically. My largest one shoots a 2.5" 15 gauge finish nail, and is used mostly for setting door frames. Been setting doors and some thick casings all week, so it has been in great demand! Today it decided to shoot 2 nails at once, and got hopelessly jammed up! Carlson Systems in Omaha is where I bought them, and they have a service department. Finished the day, and by 4:15 I was at Carlson. Told him I had 4 more doors to set, and I joked about how it could not quit when it WASN'T needed! He proceeds to take it apart, clean it, test it, then offered preventative measures, AND did not want even a penney for his trouble! I was IMPRESSED!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
