Posted by Billy NY on March 21, 2012 at 11:51:15 from (67.248.100.3):
In Reply to: OT wash stalls posted by Heyseed on March 21, 2012 at 11:39:52:
What size slab, pitched or sloped to a drain or surface run off ? 12" on center each way # 4 deformed bar would work, you could go up a size or 2 but unnecessary, especially if also using Woven Wire Mesh,to be honest the rebar would suffice, 4000 PSI concrete with a non slip surface.
Do be aware that concrete is porous, it has capillaries if using as a wash stall, might pay to use epoxy covered rebar, to prevent any corrosive action with the rebar, that will spall concrete in a hurry, as it expands several times its original size causing fracturing etc. used to happen on bridge decks all the time, years back, rebar to close to the surface, salt used for de-icing, and other contributing factors.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.