Posted by Hobo,NC on March 29, 2012 at 05:09:42 from (98.17.83.119):
In Reply to: Here's a dumb one posted by Old Popper on March 28, 2012 at 09:07:46:
Quoting Removed, click Modern View to see
My biggest beef with lick'em and stick'ems on the emissions side of it. If a businesses is not qualified to repair emissions you should not be able to attempt to fix it.... A emission inspector should be ASE certified as a Master and Advanced engine performance... Most all the cars I get have been to the local parts changers that have no ID what they are doing and have wasted the customers money parts swap'n to try and get the check engine light out...
Its a damm shame so many shops depend on inspections to stay in businesses around here by using their best guess to to fix it,,, its a total consumer rip off... I think inspection stations should be owned and operated by the state,,, If they could make money at it they would but they can not...
I don't depend on the chump change a inspection generates and will fail one in a heartbeat,,, I have to much invested in the equipment to let it set idle,,, here you are charged with a felony and have to go to court the fines are steep if you get caught cheating... The only reason I do'em is so I can Finnish up a check engine light repair...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
