Posted by M-MAN on April 09, 2012 at 22:21:44 from (184.39.47.179):
In Reply to: Re: 420carb posted by Scott meeuwsen on April 09, 2012 at 21:01:55:
Are you sure the plug wires are on correctly? If it's timed right the no 1 post will be on the front side and no 2 just a tad left of center. BTW don't pay the manual any attention when timing cause it's wrong. Set it like I posted but the point gap has to be set first. 19 to 21 is what it should be. I would put in new points and condensor if you haven't.
On the carb the slotted head screw with a spring is your idle screw. The load screw is near the bottom & is an L or T end for adjusting. It's just a drain petcock on the bottom. There is a screen filter in the elbow where the fuel iine go's into the carb. It must be clean. The nozzle is under the load adjusting needle and bushing. Takes a BIG screwdriver to remove and clean it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
