Posted by chas on April 22, 2012 at 14:25:28 from (93.23.203.235):
In Reply to: starter commutator posted by montidale on April 22, 2012 at 10:46:29:
The pro's use a fibre-glass rod, however unless the commutator is badly scored or pitted it shouldn't be necessary to use abrasive. Ideally, if the scoring is not great and the surface is just dirty, use only a solvent to clean down and inspect. The working surface area ideally should be a 'chocolate brown' colour (once you get rid of the carbon), identifiably darker than the 'unbrushed' areas. If this is the case, the copper has been surface hardened, polished and is in best possible state. Removing this with abrasive takes it back to soft copper and increases wear. Clean between the segments with a toothpick or matchstick, clean off again with solvent. Light scoring is no problem, new brushes will bed in over it. Make sure the brushes / holders dont bind and spring pressure is good. If the commie is grooved or heavily scored it may need skimming. If the brushes are worn short enough to reduce spring pressure, then replace them. To bed-in new brushes, wrap a strip of emery - rough side up - around the commie, allow the brushes to press against it and rock the commie to shape the brush.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.