Inno said: (quoted from post at 08:34:55 05/12/12) Not sure if the picture is showing up. After taking some measurements and finding a document which shows the measurements of the different types of pump flanges this is what I conclude.
I have a type A flange on the tractor (2 bolt, 3.25" pilot) and the pump is a type B which is a larger mount. So I would have to adapt, probably with a plate of some sort from type A to type B.
Inno,
Currently have my main computer down, working from ipod. I found a bunch of links before about cessna pumps. My pump is the same number as your. Type A hole flange and what I remember mine runs CW but my engine is the 3 cyl perkins deisel so maybe runs opposite than your gas. I recall calling the surplus center and he told me how to determine rotation. Can't recall what he said but maybe a call would help you too. As far as pressure and flow goes, from the links I found I seem to recall our Cessna had a flow around 10 gpm @ 1200 rpm and 12 gpm @ 1400 so 1.87, 1.92 or 2.02 cu in/rev would be minimum. I was always curious about how much flow and pressure the external stuff needed. One link someone said 10 gpm is enough for the loader. But if you need 3 gpm for your ps then how much for your backhoe or I have 3 pt rams on rear then how much flow and how much pressure is needed and how much is too much...don't want to bow ram seals.
This post was edited by jfharper at 11:26:24 05/12/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.