Posted by NCWane on May 22, 2012 at 06:50:04 from (69.40.232.132):
In Reply to: pinhole in oil pan posted by mkirsch on May 22, 2012 at 06:10:41:
Being an oil pan it's a bit thicker than some other tanks so I'd probably braze it. That being said, I've also had good luck using a small diameter, low melting temp solder to repair corroded places where there were multiple pin holes that showed up after cleaning the area to repair the one pin hole that origionally needed repair. In that case the sheet metal on the tank was relatively thin anyway, as compared to most oil pans, so I knew it wouldn't take the heat needed to braze it without melting completely and forming large holes that wouldn't be easily repairable. In that instance I used a really fine/small diameter solder designed for doing electronics, but I have even used standard 50/50 solder like you'd use for nonpotable, copper water pipes. As far as brazing rod, just use as small of a diameter rod as you can get to limit the amount of heat needed to be put into the repair to get the rod to melt before the base metal in the pan does.
The main thing doing either type repair is to get the area as clean as possible so the braze or solder will bond to the metal/Tin and flow out to give a good repair. At one point in time Dad had some nearly pure muratic acid that worked great for leaning things prior to soldering or brazing. Nowdays I use a dilluted muratic acid that is designed for cleaning out piping systems. Although it isn't as good as the pure stuff it will remove any oil, grease, etc that tends to the repair metal from bonding. Beyond that all I can say is good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
