Posted by Buzzman72 on May 25, 2012 at 11:16:39 from (74.129.196.127):
I just wanted to give a compliment where one is due. A few months back, I mentioned that on a Knight muzzle loader I bought used, the plastic guide on the bottom of the barrel that holds the ramrod had cracked, and allowed the ramrod to rattle in the woods, as well as not holding it firmly in its place.
I finally got around to calling the company last week, after looking all over the internet for the right part and coming up empty. When I got their voice mail system during regular business hours, I really didn't have high hopes that I'd get my problem solved.
I was wrong. On Monday, i received a call back from someone at Knight Rifles, and he told me that the new guide is metal, and available in either stainless or blued finish. I told him my rifle was blued, and the gentleman told me he'd send me the part. As I was reaching for my debit card to pay for the part, he told me that he was sending me the replacement part FREE OF CHARGE. And, true to his word, I received the correct part yesterday in the mail, at no charge.
I'm still amazed and astounded. I wasn't even the original purchaser of the rifle, but I've had a ton of fun with it. And if I ever do replace this rifle, I'm going to buy another Knight Rifle. It's a small part, but they just made a lifetime customer out of me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
