Posted by old on May 31, 2012 at 22:01:42 from (209.86.226.40):
In Reply to: MOVING BIG ROCKS posted by Detmurds on May 31, 2012 at 18:42:42:
A lot depends on what tractor you have. A 500lbs rock on the end of a boom pole behind an 8N is going to have you doing wheelies but on say a 4020 JD then maybe. By the way if you figure the rock is 500lbs best add half again to it. I have a rock that I can shake with my back hoe on my 8N ford but the Cat 950 loader machine I have will not even begin to move it. I know since I hook up a chain around that rock and all I could do was lift the rear end of that 950 off the ground and that is a big 40,000lbs machine with a 2.5 yard bucket
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
