Posted by JDseller on June 02, 2012 at 23:38:19 from (208.126.196.144):
In Reply to: JD 30/20 powershift posted by Michael Cousen on June 02, 2012 at 16:16:48:
Like Cliff stated below the lever is the tow disconnect lever. The lever itself is made to spring side ways and lock into the deck plate. Put your deck plate back on. Then if the lever does not lock in place just bend it a little so it is pre-loaded against the deck plate.
To get it to engage I usually rock the tractor back and forth on the tire. DO NOT HAVE THE TRACTOR RUNNING!!!!!! when engaging this. Two very important reasons for that. 1) It can run over you if it is not in park. 2) The shifter is just a splined hub and it is not made to be engaged while running. I have seen guys do it while it is running and strip the splines out of the hub. You have to remove the rock shaft housing and a bunch of other stuff to replace that coupler. SO DON"T ENGAGE it while running.
Another thing get an operators manual. There is different knowledge needed to service and operate a PS than a syncro range transmission. The operators manual goes over all of the controls on the tractor including the tow dis-connect lever.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
