I had to teach myself also, my way is a bit different. I have a basic old ford and a six foot long pry bar. I just back into the implement close to the right location on one try, lower the lift arms a couple of inches below the pins and set the brakes. Then with the bar I simply pry one side of the implement to where I can hook the ball over the pin and install the clip, then do the other side the same way, then the top link and pto shaft, if the implement has one. Takes about two minutes, no struggle, real easy. My tractor has a loader so I attached a two inch dia. pipe on a vertical support and carry the bar in it, never leave the garage without it. I set the arms below the pins because I find it easier to lift them to the pins. I also have the "topper" sitting on blocks so it is easy to fit the bar under the ends or sides as needed to move it where I want it. I"m old, skinny and weak so I find the easy way to do things when possible.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
