Posted by Fixerupper on July 18, 2012 at 17:14:10 from (100.42.82.164):
In Reply to: JB weld ? posted by George Marsh on July 18, 2012 at 14:53:35:
JB will work fine at the temp the intake side of that engine runs as long as the part is reinforced a bit. A plate or pipe or screws will halp take the vertical and push and pull stress off. I would imagine the JB will start losing strength at a certain temp but still hold with some help from something solid. Gasoline does eventually, with time, soften JB. When you hit the kill switch to shut her down that piston is still pulling in fuel till all rotation stops and I imagine that intake port will be a little wet with gas until it evaporates. The engine might be worn out before the gas does it's damage, but it's just a thought.
A machine shop once told me they worked on a head that had been rebuilt by a rebuilder sometime before they worked on it and they found a hole in an intake port that had been JB'd and it still looked good after the head had been on a running car engine for awhile. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.