One blade missing, that would shake like heck, when I removed my blades, by accident, LOL, it left a nice neat pile, blades, bolts, broke of course, found all the washers too.
I will say this, while in highschool, farmer had let our place sit for 6 years, he wanted to use it again, so I had to cut the entire place, 50+ acres tillable, with a 2010 JD narrow front, and a borrowed Bush hog brand cutter, in the top field, I hit a round rock the size of a softball and it went up the back side of me on the seat, up and clear over into the next field, over the hedge row of trees, can you imagine getting hit by that cannon ball ? Never saw anything like it since and I have hit plenty of similar rocks with this poor ole SE-6 that I try like heck to take care of, one thing about it, really are not any guards on it, but it just does not send projectiles out, I think what happened had a lot to do with adjustment, tilted down, hard to see it tossing something toward the operator, but guards are best to have anyway, to be safe. I likely did not have that one adjusted right on the 2010, but I immediately went and found ours which was loaned and used it for the rest of the job, as it had front swinging steel plate guards, man if that had hit me, would have taken my head off, knocked me off or out, and the tractor into the hedgerow, was alone doing this.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
