Posted by NCWayne on August 01, 2012 at 14:53:38 from (69.40.232.132):
In Reply to: Marvel Carb posted by Don E. Foster on August 01, 2012 at 12:54:59:
Like Old said if it has a needle with the rubber tip thye will often need to be tapped lightly to seat them before they will seal. I had a carb once that I couldn't get to seal for anything. I got spart one night and decided to seat it like you'd lap a valve in. So, I wrapped a piece of thread around the needle and spun it in the seat with lite fingure pressure on it. That was more than 5 years ago and it hasn't leaked a drop since.
If the needle doesn't have a rubber tip I've seen those that also needed the same treatment to get them to seat. The biggest difference is that when tapping them it takes just a bit more of a tap than the rubber ones do. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
