Posted by JerryS on August 02, 2012 at 12:27:24 from (98.80.104.219):
In Reply to: O.T. Getting scared posted by Row Crop on August 02, 2012 at 03:46:55:
A reading of this thread reveals one sad, central truth: even though the constitution acknowledges (not gives) our RIGHT to own and carry, "reasonable" limitations continue to be imposed through the years, each successive one opening the way for more, newer "reasonable" limitations that will ultimately erode that original right into meaningless.
Sure, it's "reasonable" to assume the average citizen has no legitimate need to own a full-auto weapon, or a mortar, or a bazooka or a stinger missle. I essentially agree, but it's the ongoing extension of such arguments that gets us to the place where it limits who can carry what, when and where. It also becomes "reasonable" to limit caliber, powder charge, projectile weight and composition, number of chamberable rounds, etc., chipping away until finally, like JRSutton, you get tired of the hassle and give up.
That's not an accidental outcome. That's the plan. I used to be irritated when the NRA so strongly defended what appeared to be "extreme" positions, such as the "cop-killing ammo". Now I know that they were simply acting on the correct belief that to surrender any ground will eventually lead to full defeat. Chip. Chip. Chip.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
